Mammotty in his recent blog had discussed about the importance of sync sound.What do we mean by sync sound??Sync sound (synchronized sound recording) refers to sound recorded at the time of the filming of movies, and has been widely used in U.S. movies since the birth of sound movies. The first animated film in which sync sound was used is Walt Disney's Steamboat Willie. The characters and the boat dance in time with the music, and the gags are sound-related.
History
Even in the silent film era, films were shown with sounds, often with musical accompaniment by a pianist keeping time with the screen action. The first synchronization was a turning recording device marked with a white spot. As the white spot rotated, the cameraman hand cranked the camera to keep it in sync with the recording. The method was then repeated for playback, but with the projectionist hand cranking the film projector."Single-system" sound recorded sound optically to part of the original camera film, or magnetically to a stripe of magnetic coating along the film edge"Double-system" sound used independent cameras and sound recorders. The first sync sound standard used recorders and cameras both powered by AC (alternating current) motors - essentially clock motors. Later the 50Hz or 60Hz sine wave, called a "Pilotone," was recorded on a second parallel track of an audio recorder.In double-system filming, speed variations of camera and recorder, as well as the elasticity of the magnetic recording tape, requires some positive means of keying the dialogue to its appropriate film frame.The inclusion on the sound recorder of a second, parallel, sync or "Pilotone" track, is the most common method in use today.If a location camera is driven by a DC motor, with some sort of governor control to hold it fairly accurate at 24 f.p.s., a sync pulse generator geared to the movement or motor shaft could be employed to provide the sync pulse output. A cable conducts the sync pulse from camera to sound recorder. The sync pulse is typically a sine wave of 50 or 60 Hz with an RMS amplitude of approximately 1 volt.This double-system audio recording could then be transferred or "resolved" to sprocketed magnetic film, with sprocket holes that match one to one with the original camera film. These two sprocketed media could be run through a "Moviola" or flat-bed editing table such as the Steenbeck for synchronous sound editing.With the introduction of the Bulova "Accutron" watch that used a tuning fork as a time reference (watches later used an oscillating electronic crystal), the camera no longer needed to be connected to the sound recorder with a cable. The camera speed was controlled by one oscillator, and a second oscillator in the recorder generated the Pilotone.This method was developed in the 1960s by pioneering filmmaker Richard Leacock. It was called Direct Cinema and was the basis for a "New Wave" of Cinéma Vérité films, especially in Europe, made by filmmakers who abandoned the studio and went out on location to film, often with hand-held cameras.In 1972 Bell & Howell brought out a consumer version of a double-system Super-8 sound filmmaking system called "Filmosound." A Compact Cassette recorder was attached to the camera with a cable that transmitted a single pulse to the recorder every time a new frame of film was exposed in the camera. On playback, the cassette recorder pulse was used to control the projector speed.A that time a professor in the MIT Architecture department Film Section, Ricky Leacock developed a Super-8 film production system with a crystal-controlled camera, a crystal-generated Pilotone cassette recorder, a sprocketed magnetic film recorder, a flatbed editing table, and a projector. The MIT/Leacock System was funded with a $300,000 grant from Polaroid founder Edwin Land.In 1973 the one-pulse-per-frame technique was used to control recording directly onto sprocketed magnetic film in the Super8 Sound Recorder.developed by inventor Bob Doyle. The Super8 Sound Recorder could also "resolve" sound that had been recorded onto cassette tape with this new "digital" sync pulse.Today, every digital video camera and digital sound recorder have very accurate crystal time references and so can be used for double-system video production.
Sync Sound in Asia
In Hong Kong, sync sound was not widely used until the 1990s, as the generally noisy environment and lower production budgets made such a method impractical.
Most Bollywood films from the 1960s onwards do not employ this technique and for that very reason the 2001 films Lagaan and Dil Chahta Hai were noted for the use of Sync sound. The common practice in Bollywood is to 'dub' over the dialogues at the Post-Production Stage, although people such as sound designer and mixer, Resul Pookutty, are endeavoring to change this. Although the very first Indian talkie Alam Ara released in 1931 saw the very first use of Sync Sound in India, and since then Indian films were regularly shot in Sync Sound till the 1960s with the silent Mitchell Camera, with the arrival of the Arri 2C, a noisy but more practical camera particularly for outdoor shoots, 'dubbing' became the norm and was never reversed. In malyalam "Loudspeaker" movies features with sync sound.Use of this technique has increased in recent times with development in film techniques and instrumentations like Arri Blimp camera.This system has been used in Hindi movie Jodhaa Akbar.
